A New Spin on Old Tradition     

    FITTING


    SHAFT LENGTH


    Once the shaft of a club is installed, it is time to determine the proper shaft length, specific to you. Determining the correct shaft length is just as important as flex, torque and other factors relating to the shaft.


    HOW TO DETERMINE LENGTH


    To determine the length of your club, stand at attention and have someone measure from the crease of your wrist, (where your wrist and hand meet), to the floor. Do this with both hands and use the average between the two sides in the following guide:


    29 to 32 inches, your irons should be based on a 5-iron of 37 inches.
    33-34 inches, your irons should be based on a 5-iron of 37 1/2 inches.
    35-36 inches, your irons should be based on a 5-iron of 38 inches.
    37-38 inches, your irons should be based on a 5-iron of 38 1/2 inches.
    39-40 inches, your irons should be based on a 5-iron of 39 inches.
    41 or more inches, your irons should be based on a 5-iron of 39 1/2 inches.


    STEEL OR GRAPHITE


    Should you go with steel shafts or graphite shafts? What are the differences between the two materials? Is one type of shaft better for you than another?


    These are questions that many newcomers and experienced golfers alike have in mind when purchasing a new set of clubs.


    In the "old days," the general feeling was that recreational golfers and mid - high-handicappers should use graphite shafts, while the more experienced, low-handicap players should stick with steel.


    Steel remains a popular choice for most golfers when it comes to consistency in performance, feel and value. Compared to steel, graphite shafts are lighter weight, softer and more shock absorbent, but are more expensive too. Trial and error is the best way to determine whether steel or graphite shafts are better for you and your particular needs.


    At JK Crew we strive to create the ultimate golfing experience for you- both in store and on the course. We offer customised products for optimal results. Select from a choice of shaft length and shaft flex to customise the feel and performance of your game, depending on your current needs and future expectations. Our experienced staff will assist you along the way to ensure that your choices are best for you and your game.


    TORQUE


    Every shaft has a Torque Rating, which is expressed in degrees. The Torque Rating describes the amount the shaft twists during the downswing, and determines how the shaft feels. The lower the Torque Rating, the greater the resistance the shaft will have.


    HOW TO CHOOSE


    Here are some considerations when looking at Torque Rating:


    The Torque Rating of any shaft will change the Swing Speed Rating and feel of the shaft. A Regular Flex shaft with a Torque Rating of 5 degrees will have a Swing Speed Rating lower than a Regular Flex shaft with a Torque of 3 degrees. The higher torque shaft will also have a softer feel.

    Decide what you need - for example, if you swing your irons at about 80 to 85 mph, and prefer a stiff feel in your irons then go for a shaft that is Regular Flex with a low torque (approximately 2.5 degrees). If you prefer a softer feel, then opt for a Stiff Flex with a high Torque of about 5 or 6 degrees.


    JK Crew will always endeavour to have all orders shipped from our Australian and American-based warehouses within 1-3 business days.


    Please note that custom orders can take up to 7-10 days to allow for your custom clubs to be assembled by our accredited club fitters.